V2 Rod’s Random Works HC T Rex Replacment Feet

V2 Rod’s Random Works HC T-Rex Replacement Feet

**

V2 Rod’s Random Works HC T-Rex Replacement Feet. I’m excited to team up with Rod once again and carry these amazing alternative feet for your Mattel HC T Rex. These fet were designed by Rod’s Random Works to be a direct replacement for the HC Rex and give it a more paleo-accurate look. These feet are 3D printed in-house using a

proprietary resin blend that makes them strong but resistant to grinding. The colour is matched to match the skin tone of the standard HC T-Rex so your figure’s new look will be seamless (a perfect match cannot be guaranteed due to variations in production).

The new V2 feet are symmetrical and can be used on either side. The sole also sports increased friction on the toes to help hold position better.

NOTE: SOME PICTURES DEPICT THE V1 FEET. V1 FEET HAVE ONE SMALL AND ONE LONG OUTSIDE TOE.

Comes unpainted.

To remove your old feet, heat them with either a hair dryer or by dipping them in “just boiled” water for a minute. While holding the leg use a towel to grasp the for and pull gently off as the foot will be hot

To install the new feet, use a hair dryer (DO NOT use hot water) to heat the feet and then press them on to the stud by only putting pressure on the "foot"; do not apply pressure to the toes.